Danfoss Maneurop KVP Evaporator Pressure Regulator
The KVP is mounted in the suction line after the evaporator and is used to:
1.Maintain a constant evaporating pressure and thereby a constant surface temperature on the evaporator. The regulation is modulating. By throttling in the suction line, the amount of refrigerant gas is matched to the evaporator load.
2.Protect against an evaporating pressure that is too low (e.g. as protection against freezing in a water chiller). The regulator closes when the pressure in the evaporator falls below the set value.
3. Differentiate between the evaporating pressures in two or more evaporators in systems with one compressor.
Features:
• Accurate, adjustable pressure regulation
• Wide capacity and operating range
• Pulsation damping design
• Stainless steel bellows
• Compact angle design for easy installation in
any position
• “Hermetic” brazed construction
• 1⁄4 in. Schrader valve for pressure testing
• Available with flare and ODF solder
connections
• KVP 12 – KVL 22: may be used in the following
EX range: Category 3 (Zone 2)
Related Products
-
Emerson Expansion Valve
Features Modular design for economical logistics and easy assembly and servicing Very good stability is attained because of the large…
-
Castel Globe Valve
APPLICATIONS The globe valves, shown in this chapter, are classified “Pressure accessories” in the sense of the Pressure Equipment Directive…
-
Castel Solenoid Expansion Valve
Solenoid valves are designed for installation on commercial refrigeration systems and commercial and industrial air conditioning systems employing HCFC and…
-
Castel Hand Valve
APPLICATIONS The diaphragm valves, shown in this chapter, are classified “Pressure accessories” in the sense of the Pressure Equipment Directive…